iRobot Braava 380t Teardown

Written By: Bossard Nicolas
  • Comments: 0
iRobot Braava 380t Teardown

Difficulty

Moderate

Steps

10

Time Required

30 minutes

Introduction

  1. SrZE3tDlPQZOUnJT

    • Flip over the Braava

    • Remove the 4 screws circled in red in the photo.

  2. erTwAgfgBWTtJt2X

    • Flip over the Bravva

    • Raise the bonnet, which should offer no resistance.

    • Disconnect the red and black wire plug.

    • Remove the cover

  3. mQEfqHZwkGKPekT1

    • The robot is now open. Take the opportunity to clean the contactors on the front.

  4. lZPFWUQ3Tp2Zsnli

    • To continue dismantling and gaining access to the motors, remove the stickers.

  5. eL5yoqWprm4vF2RK

    • The screws of the engine covers are then clearly visible.

  6. PmFxFQlyRNvHSSVO

    • Remove the covers

    • Do not try to pull the engine out at this time!

  7. GkLBWOysMRygVHFK

    • Remove the wheel cover by turning it a few degrees

  8. TcTb56NXaHNCU5FZ
    TcTb56NXaHNCU5FZ
    I4fUk6ItXr2xMAni

    • Remove the circlip using special pliers (cut here to be small enough)

    • Take out the wheel, clean the inserted hair

  9. PUqdoi4mPCB42r2B

    • Undo the 2 screws. Next, remove the wheel guard.

  10. ttatWFTZHNvjC5ai
    ttatWFTZHNvjC5ai
    pTqTcNMEQPxEgVKF

    • You can then remove the motor and possibly dismantle the gearbox.

Conclusion

To reassemble your device, follow the instructions in reverse order.

Author

Bossard Nicolas

Member since: 21/09/18

1143 Reputation

0 comments