Uranium–lead dating

Uranium decays to lead via a series of alpha and beta decays, in which ²³⁸U and its daughter nuclides undergo a total of eight alpha and six beta decays, whereas ²³⁵U and its daughters only experience seven alpha and four beta decays.[4]

The existence of two 'parallel' uranium–lead decay routes (²³⁸U to ²⁰⁶Pb and ²³⁵U to ²⁰⁷Pb) leads to multiple feasible dating techniques within the overall U–Pb system. The term U–Pb dating normally implies the coupled use of both decay schemes in the 'concordia diagram' (see below).

However, use of a single decay scheme (usually ²³⁸U to ²⁰⁶Pb) leads to the U–Pb isochron dating method, analogous to the rubidium–strontium dating method.

Finally, ages can also be determined from the U–Pb system by analysis of Pb isotope ratios alone. This is termed the lead–lead dating method. Clair Cameron Patterson, an American geochemist who pioneered studies of uranium–lead radiometric dating methods, used it to obtain one of the earliest estimates of the age of the Earth.

Although zircon (ZrSiO₄) is most commonly used, other minerals such as monazite (see: monazite geochronology), titanite, and baddeleyite can also be used.

Where crystals such as zircon with uranium and thorium inclusions cannot be obtained, uranium–lead dating techniques have also been applied to other minerals such as calcite / aragonite and other carbonate minerals. These types of minerals often produce lower-precision ages than igneous and metamorphic minerals traditionally used for age dating, but are more commonly available in the geologic record.

During the alpha decay steps, the zircon crystal experiences radiation damage, associated with each alpha decay. This damage is most concentrated around the parent isotope (U and Th), expelling the daughter isotope (Pb) from its original position in the zircon lattice.

In areas with a high concentration of the parent isotope, damage to the crystal lattice is quite extensive, and will often interconnect to form a network of radiation damaged areas.[4] Fission tracks and micro-cracks within the crystal will further extend this radiation damage network.

These fission tracks act as conduits deep within the crystal, providing a method of transport to facilitate the leaching of lead isotopes from the zircon crystal.[5]

Under conditions where no lead loss or gain from the outside environment has occurred, the age of the zircon can be calculated by assuming exponential decay of uranium. That is

${\displaystyle N_{\mathrm {n} }=N_{\mathrm {o} }e^{-\lambda t}\,}$

where

• ${\displaystyle N_{\mathrm {n} }=\mathrm {U} }$ is the number of uranium atoms measured now.
• ${\displaystyle N_{\mathrm {o} }}$ is the number of uranium atoms originally - equal to the sum of uranium and lead atoms ${\displaystyle \mathrm {U} +\mathrm {Pb} }$ measured now.
• ${\displaystyle \lambda =\lambda _{\mathrm {U} }}$ is the decay rate of Uranium.
• ${\displaystyle t}$ is the age of the zircon, which one wants to determine.

This gives

${\displaystyle \mathrm {U} =\left(\mathrm {U} +\mathrm {Pb} \right)e^{-\lambda _{\mathrm {U} }t},}$

which can be written as

${\displaystyle {{\mathrm {Pb} } \over {\mathrm {U} }}=e^{\lambda _{\mathrm {U} }t}-1.}$

The more commonly used decay chains of Uranium and Lead gives the following equations:

${\displaystyle {{^{\text{206}}\,\!{\text{Pb}}^{*}} \over {^{\text{238}}\,\!{\text{U}}}}=e^{\lambda _{238}t}-1,}$

(1)

${\displaystyle {{^{\text{207}}\,\!{\text{Pb}}^{*}} \over {^{\text{235}}\,\!{\text{U}}}}=e^{\lambda _{235}t}-1.}$

(2)

(The notation ${\displaystyle {\text{Pb}}^{*}}$, sometimes used in this context, refers to radiogenic lead. For zircon, the original lead content can be assumed to be zero, and the notation can be ignored.) These are said to yield concordant ages (t from each equation 1 and 2). It is these concordant ages, plotted over a series of time intervals, that result in the concordant line.[6]

Loss (leakage) of lead from the sample will result in a discrepancy in the ages determined by each decay scheme. This effect is referred to as discordance and is demonstrated in Figure 1. If a series of zircon samples has lost different amounts of lead, the samples generate a discordant line. The upper intercept of the concordia and the discordia line will reflect the original age of formation, while the lower intercept will reflect the age of the event that led to open system behavior and therefore the lead loss; although there has been some disagreement regarding the meaning of the lower intercept ages.[6]

Undamaged zircon retains the lead generated by radioactive decay of uranium and thorium up to very high temperatures (about 900 °C), though accumulated radiation damage within zones of very high uranium can lower this temperature substantially. Zircon is very chemically inert and resistant to mechanical weathering – a mixed blessing for geochronologists, as zones or even whole crystals can survive melting of their parent rock with their original uranium–lead age intact. Thus, zircon crystals with prolonged and complicated histories can contain zones of dramatically different ages (usually with the oldest zone forming the core, and the youngest zone forming the rim of the crystal), and so are said to demonstrate "inherited characteristics". Unraveling such complexities (which can also exist within other minerals, depending on their maximum lead-retention temperature) generally requires in situ micro-beam analysis using, for example, ion microprobe (SIMS), or laser ICP-MS.