CHI Spin N Curl Rotating Curler Temperature Control Switch Replacement

Geschrieben von: Annalise White
  • Kommentare: 0
CHI Spin N Curl Rotating Curler Temperature Control Switch Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

20 - 40 Minuten

Einleitung

If the buttons on your CHI Spin N Curl Rotating Curler (model number CA2288) are not setting the proper temperature, follow this guide to replace the temperature control switch.

The temperature control switch will properly set the temperature on your curler. A faulty control switch will not set your curler to the correct temperature.

Before using this guide, inspect the curler for a faulty heating component. The curler may not be heating up, and the heating component may need to be replaced.

Before beginning, make sure to power off your curler and disconnect from any external power source.

  1. QQAcNGQWaHpFd1Lu

    • Use a metal spudger to pry off the silver, shiny trim.

  2. WXZIAikakUXuCYLf

    • Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

  3. FmsguqA3EhGWYARm
    FmsguqA3EhGWYARm
    Rn4xAQ3Be5YLybSW

    • Use a 2 mm flathead to remove the two screws.

  4. kRANKNE1oydI6yAE
    kRANKNE1oydI6yAE
    vcPRTjNXG1CQKrly

    • Use a metal spudger to pry open the seams of the device.

  5. QQBEivNkOQAGjYnW
    QQBEivNkOQAGjYnW
    pNw2qTyE6K1QwLGP
    1erXxJjucZYjIgyV

    • Toward the bottom of the device, grab the swivel power cord.

    • Gently pull the power cord to detach it from the CHI Spin N Curl

    • Replace the faulty cord when the original cord has been removed.

  6. TQrS3LPFaQXXmEGO

    • Use a Phillips #00 screwdriver to remove the screws on both sides of the temperature control switch.

    • Pop out the control switch.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Annalise White

Mitglied seit: 26/10/22

512 Reputation

0 Kommentare