Einleitung
It is important to clean the A/C filters every few months, otherwise, the accumulation of dirt on A/C filters can cause the device to function improperly and expose users to the circulation of dirty air inside homes. This guide will explain the process of cleaning the filters inside a split air conditioner unit.
The steps are shown for the Zanussi split A/C; however, the guide can also be used for other similar models. In addition, the guide can be used for replacing filters in your split A/C. Follow the instructions for detailed explanations.
Werkzeuge
-
-
Turn off the air conditioner using the remote controller.
-
Unplug the A/C unit from its power source.
-
-
-
Grab the filter by the small tab located at the bottom.
-
Pull the filter towards yourself to snap it out of the slot that holds it in place.
-
Pull the whole filter out of the A/C unit.
-
-
-
Buy filters that are specifically made for your model of the air conditioner. Otherwise, the filters might not fit into the unit or the device may not function properly.
-
Skip steps 5-7 and continue with step 8 after you’ve purchased your new filters.
-
-
-
Wash the filters under streaming water:.
-
Slide the filter from side to side to ensure every part of the filter is washed with the stream.
-
-
-
Place your filters in a bucket with one part water and one part vinegar.
-
Leave for one hour to soak.
-
Wash the filters in circular motions with a soapy sponge.
-
Rinse the filter thoroughly with water.
-
-
-
Place your filters on a towel in a dry room and let them completely dry out before proceeding to the next step.
-
-
-
Place the filters back inside, pushing them forward until they click and fall back into place.
-
To reassemble your device, close the lid of the A/C and plug it into power.
