Einleitung
This repair guide will walk the user through the steps required to access and remove the internal battery of the Coby Kyros MID7024. Be sure to refer to the list of needed tools.
Werkzeuge
-
-
To replace the back cover of the device you must pry it open using the access points. One is located on the top of the device above the camera and the other is on the bottom left hand side.
-
Use the spudger to pry at the access points to open the device.
-
-
-
Once the back cover begins to separate from the body of the device continue working the spudger around the perimeter of the device until the back cover is free.
-
Once the back cover is free from the body of the device, open both sides like a book, placing them flat on the table as shown. Be sure to pay attention to the speaker wires that hold the two pieces together.
-
-
-
In order to replace the back cover you must remove the speakers. Place the Spudger under the plastic frame of the speaker as shown. Pry up, popping the corners of the speakers out of of their bracket and lift the speaker out.
-
-
-
Locate the black tape connected to the battery and peel it back as indicated in the images.
-
-
-
After the battery is freed from the device, it will remain connected to the motherboard by two short wires.
-
Use the spudger tool to gently pry around both sides of the battery until it can be lifted from the device.
-
Roll the battery over (as shown in the image) so that its underside is now facing up. This will prevent damage to the motherboard.
-
-
-
Use a soldering gun to remove the positive and negative wires connecting the battery to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
