Einleitung

Use this guide to replace a full or faulty battery in your Garmin StreetPilot c330

The Garmin StreetPilot c330 is a device that comes with automatic route calculation to any destination, and turn-by-turn voice-prompted directions. If your Garmin StreetPilot c330 no longer stays turned on if unplugged despite being charged for a reasonable amount of time. This is usually a sign of an old or damaged battery. In this case, replacement is necessary.

Before using this guide, make sure to review the troubleshooting page—oftentimes, problems with loose charging cables or damaged charging cables could cause a problem.

A punctured battery can cause a dangerous fire. If your battery is swollen, take appropriate precautions.

Make sure to power down your device before you begin.

  1. f1mDTqvNKaKmPG5F
    f1mDTqvNKaKmPG5F
    WufBcIBPMmo1YfpV
    cCyNVHnIyZKQ42Xc
    • At the top of the outer frame, insert the plastic spudger into the groove in the center.

    • Lever the frame gently until it pops out of the case.

  2. MjFTNlZvVNNcpcaf
    MjFTNlZvVNNcpcaf
    eKFESYOX1GOTf65U
    6ZVBhfcG3EdOHHjR
    • Use a Phillips #00 screwdriver to remove the four screws around the screen.

  3. WxMImTL1XEyboNoi
    WxMImTL1XEyboNoi
    1bUxESy2SAMgQVXC
    • Gently pull from both ends of the casing to separate the front and back panels.

    • Do not force the pieces apart wider than the length of the connecting wires, or you will damage the wiring.

  4. unMPuZrswsFlqTNh
    unMPuZrswsFlqTNh
    tDGKj4LIH52pYLkB
    RuAHbLPNVBoJaBR5
    • Gently unplug the white cable connector using either your fingers or tweezers.

  5. BeNJjmsH6PVIFEUr
    • Carefully expose both halves of the device.

    • Be sure not to pull the two halves apart further than the black wire can reach.

  6. 4nBkuq3ohRBnSptd
    4nBkuq3ohRBnSptd
    vVa1blbCiLbQD5BG
    Sek65C2Q3BfrS4iD
    • Use a Phillips #00 screwdriver to remove the two screws from the battery bracket.

  7. xXcbBLTFW1uSICJi
    xXcbBLTFW1uSICJi
    XjcAf2hsXCcL4JrL
    nwtZPuYQiKw5NR6i
    • Carefully peel the metal bracket away from the battery.

    • Pull the battery away from the back cover.

    • Desolder the wires from the speakers using a soldering iron.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Adrian Leon

Mitglied seit: 07/10/10

173 Reputation

0 Kommentare