Einleitung
If the buttons on the device are not responsive, you may need to replace them, and this guide will show you how to do that, but does involve some soldering.
Werkzeuge
-
-
Lift the four adhesive covers on each of the corners on the bottom of the clock using a plastic opening tool or your fingernail.
-
-
-
On the bottom of the clock, use your fingernail to push the battery cover to the right.
-
Lift the battery cover up and to the right to reveal the batteries.
-
-
-
Remove the two AA batteries by pressing the end opposite of the spring towards that spring and lifting up.
-
Once the batteries are removed, close the cover.
-
-
-
Use a long Phillips #2 screwdriver to unscrew all six 10mm Phillips screws inside the bottom of the clock.
-
Turn over the device to allow the screws to fall out, being careful to catch them so that you do not lose any.
-
-
-
Turn the clock back over.
-
Lift the top off of the clock by gripping the back of the iPhone dock and pulling straight up.
-
-
-
Using the Phillips #2 screwdriver, unscrew the seven 6mm Phillips screws on the circuit board that is attached to the top of the case.
-
-
-
Detach the circuit board from the rest of the clock by gripping the sides of the white ribbon cable connector on the left-hand side of the board and pulling it straight off. You may need to use tweezers to grip the connector.
-
To reassemble your device, follow these instructions in reverse order.
