Einleitung

Prerequisite Only

  1. ckD4hlhmUnmKSNxm
    ckD4hlhmUnmKSNxm
    4tDyZWvui5LNVpRd
    PsRGa3leqYQsXNd2
    • Before you begin this guide, make sure to disable the internal battery, power down your device, and disconnect from any external power sources.

    • Place the laptop so that the bottom is facing upwards.

    • Slide the latch on the left side of the battery to the left until it clicks in place.

  2. ubILtEnaxUXSvQlT
    ubILtEnaxUXSvQlT
    rGEYTyc3CtYNLMWC
    rouQwBIBUSLcuIYw
    • Slide the latch on the right side of the battery to the right and hold it in place with your thumb.

    • Use your other hand to slide the battery towards the back of the laptop.

    • Lift the battery up and away from the laptop.

  3. sUJqVdj3VDEM2PKE
    sUJqVdj3VDEM2PKE
    l1khsONGBiQoGnOi
    • Use a Phillips #1 screwdriver to loosen the six captive screws on the bottom cover of the laptop.

  4. riqJ6rJDpf3JWyf2
    riqJ6rJDpf3JWyf2
    hOqcZdmNLRHr6xpq
    • Place the laptop so that the top is facing upwards.

    • Open the lid of the laptop.

  5. FVyhVAXuspLJdACf
    FVyhVAXuspLJdACf
    BlGseeb6MiE4Eidi
    • Place your fingers on the bottom edge of the keyboard.

    • Use a small amount of pressure to push the keyboard towards the screen.

  6. XMtlRORcRxZNlnr6
    XMtlRORcRxZNlnr6
    eEpjVDwqZFpbCQOa
    B5OJyhW32gVcpWFA
    • Grab the bottom edge of the keyboard with your hands, and flip the keyboard upside-down, so it rests on the bottom of the laptop.

    • Potential for device damage: The keyboard is still attached to the rest of the laptop, so be gentle when flipping it over.

  7. WYUTKeCX3GEQqu5O
    WYUTKeCX3GEQqu5O
    4WXQDEHChvboCWIR
    • Use the flat end of a spudger to flip up the locking flaps securing each of the two ribbon cables.

  8. 3FuvZ1FcyRhAsQxN
    3FuvZ1FcyRhAsQxN
    BDKUbnGGGVbkbpSc
    • Use your hands to lift the keyboard up and away from the laptop.

  9. gvuuHqYo6MMOMqgL
    • Close the laptop's lid and flip the laptop over so that the bottom is facing upwards.

  10. VZFKLhJJZceH2yio
    VZFKLhJJZceH2yio
    GywdTTUcSW154Lnm
    PCqYQGhFrdPjStuG
    • Use your hands to pull up on the back cover and release the plastic clips starting on the bottom side of the battery compartment.

    • Potential for device damage: Be sure to detach the plastic clips in this area first. You risk cracking the bottom cover if you attempt to detach it from around the edges of the laptop first.

    • Use your hands to pull up on the right side of the bottom cover to release the plastic clips.

    • Use your hands to pull up on the left side of the bottom cover to release the plastic clips.

  11. UXpKCgoQprbHWRJ6
    • Remove the bottom cover from the laptop.

  12. l6dSEeg41w3jTkWF
    l6dSEeg41w3jTkWF
    hyPaCe1FM1uJRgWK
    • Use a Phillips #1 screwdriver to remove two 5 mm screws from the internal battery.

  13. hbTTnsrcyuKUOLT2
    hbTTnsrcyuKUOLT2
    Mnyenf6h3nIHl3QG
    ZlrbBZYMNaC2jR5S
    • Use your hands to lift the battery up and away from the laptop.

  14. jVDRrXRCvU5ChT5A
    jVDRrXRCvU5ChT5A
    Jg2ITIdCenQtuKM5
    • Use your fingers to flip the black flap covering the top stick of RAM down.

  15. ENeagmwFecOvy2uq
    ENeagmwFecOvy2uq
    E1sGFN2ob6cPVYQL
    • Use your thumbs to push the metal clips on either end of the RAM outwards.

    • The RAM will pop up by a few millimeters.

  16. iE1l1JmNUmA2ZpNK
    iE1l1JmNUmA2ZpNK
    ofSP3iEIN66yDxIT
    • Use your fingers to lift the RAM out of its socket and away from the laptop to remove it.

  17. ArKiANjAVSB5ELjF
    ArKiANjAVSB5ELjF
    3CRLWqKbBhgfFKrx
    dEYKe63RRLB14vEP
    • Use your fingers to flip the black flap covering the bottom stick of RAM up.

    • Use your thumbs to push the metal clips on either end of the RAM outwards.

    • The RAM will pop up by a few millimeters.

  18. gGEuKDYxbXtHLGG3
    gGEuKDYxbXtHLGG3
    jXMo3oc3ZSe5wPaN
    • Use your fingers to lift the RAM out of its socket and away from the laptop to remove it.

  19. OLPWCO2bjoXFYrqJ
    OLPWCO2bjoXFYrqJ
    VG2om6InJ2ZljJxL
    • Use the flat end of a spudger to flip up the metal clip securing the SSD connector to the motherboard.

  20. WTZKjPkQEqsOMqvq
    WTZKjPkQEqsOMqvq
    CehiLFsT2eOddLJU
    • Use the flat end of a spudger to separate the connector from its socket.

  21. WGsHphrtWWQZKrL1
    WGsHphrtWWQZKrL1
    PTSWbdbJjhkfBVaH
    • Grab the tab on the left side of the hard drive, and pull up to remove it from the laptop.

  22. ug4o2DOhZLPoaVNT
    ug4o2DOhZLPoaVNT
    53JeFCeDtKM22SCS
    • Use a finger to press the black flap covering the Wi-Fi card down.

  23. OqNnaXNNm5EDRFar
    OqNnaXNNm5EDRFar
    v1gmnI6PnFEFreJI
    PZ2noykTjW51sRIE
    • Use the flat end of a spudger to disconnect the two coaxial wires from the Wi-Fi card.

    • When reassembling, reattach the gray wire on the left and the black wire on the right.

    The connectors on the wifi card snap off pretty easily and can get stuck inside of the coaxial cables.

    Allen -

  24. wrLHQOHVNJFrretP
    wrLHQOHVNJFrretP
    M1JWF43fdklMNVar
    • Use a Phillips #1 screwdriver to remove the single 4 mm screw from the Wi-Fi card.

  25. AkJp1DytrWyZqCdZ
    AkJp1DytrWyZqCdZ
    ZBHIPqWTJshA5OPQ
    FyputJaEZEIbHtJA
    • Use your fingers to lift the Wi-Fi card up and out of its slot.

    • This laptop does not include a WWAN card, but if yours does, follow the same procedure as Steps 9-12 to remove it.

  26. 5VCHhwIdujEQpqvJ
    5VCHhwIdujEQpqvJ
    NCHGsMWwYvK5vTL1
    • Use a pair of blunt nose tweezers to pull the white connector out of its socket.

  27. q4thOPCBIxaPK4mt
    q4thOPCBIxaPK4mt
    GdATDrGYJt1MhVcQ
    BYNiqRGslktowGG5
    • Grab the wire attached to the coin cell battery, and lift it up and out of the laptop.

  28. LjPwqfdEvgLJ4bCd
    LjPwqfdEvgLJ4bCd
    L3dsf453nXduywEb
    • Use a pair of blunt nose tweezers to pull the white fan connector out of its socket on the motherboard.

  29. CCoxhTbwuLwXrlxd
    • Use a Phillips #1 screwdriver to loosen the first pair of captive screws on the fan and heat sink assembly in a crosswise pattern.

    • Use a Phillips #1 screwdriver to loosen the second pair of captive screws on the fan and heat sink assembly in a crosswise pattern.

  30. SHognB4PwvJLD65l
    SHognB4PwvJLD65l
    lDLvoF3UrvBMvVBc
    • Use your hand to pull the fan and heat sink assembly up and away from the laptop.

    • Clean the thermal paste from the heatsink and CPU and reapply fresh paste before reassembling.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kristen Gismondi

Mitglied seit: 12/11/14

71827 Reputation

0 Kommentare