Logitech MX Anywhere 2S Mouse Feet Replacement

Geschrieben von: Alex Diaz-Kokaisl

Kommentare: 0

Logitech MX Anywhere 2S Mouse Feet Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

10 - 20 Minuten

Einleitung

Use this guide to replace the feet (also called skates or pads) on your Logitech MX Anywhere 2S.

Werkzeuge

Schritt 1

If you're planning to reuse your mouse feet, you'll need to thoroughly heat them for a clean removal.
Heat an iOpener and apply it to the bottom of the mouse for one minute.
Alternatively, use a hair dryer to lightly heat the mouse feet.
Don't heat the mouse more than warm to the touch—the plastic lower case may warp or melt.

Schritt 2

Insert an opening pick between the mouse foot and the body.
Make sure the pick is underneath the foot and the adhesive layer. It's easy to separate these two layers.
Slide the pick under the foot to separate the adhesive.
If the pick feels stuck, apply more heat before continuing.

Schritt 3

Use tweezers, or your fingers, to remove the mouse foot.

Schritt 4

Repeat the previous two steps for the three remaining feet.

Schritt 5

For installing new mouse feet or reusing your old ones:
Use a pair of tweezers or a spudger to remove any large chunks of leftover adhesive.
Thoroughly clean the bottom of the mouse with isopropyl alcohol and a lint-free of microfiber cloth, and allow the surface to dry completely.
Peel your new mouse feet away from their adhesive liners and press them firmly into place.

Abschluss

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Tinte & Feder

Alex Diaz-Kokaisl

Mitglied seit: 16/01/22

69204 Reputation