Logitech MX Master 3S Mouse Feet Replacement

Geschrieben von: Alex Diaz-Kokaisl
  • Kommentare: 1
Logitech MX Master 3S Mouse Feet Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

10 - 20 Minuten

Einleitung

Use this guide to replace the feet (also called skates or pads) on your Logitech MX Master 3S.

  1. AF2uNp6RZmp3LGDm
    AF2uNp6RZmp3LGDm
    FmHkfrZWmKXTDg6H
    m2ZvHhq1NV63ri6T

    • If you're planning to reuse your mouse feet, you'll need to thoroughly heat them for a clean removal.

    • Turn off your mouse and flip it over.

    • Heat an iOpener and apply it to each of the mouse feet for one minute.

    • A hair dryer may also be used, but be careful not to overheat the mouse—the plastic body may warp or melt.

  2. eGkqhNgxWtWXWJXZ
    eGkqhNgxWtWXWJXZ
    6eDLQVt5PQmHCREi
    PJIDmuaMREE2W5Kd

    • Insert an opening pick between the mouse foot and the body.

    • Make sure the pick is underneath the foot and the adhesive layer. It's easy to separate these two layers.

    • Slide the pick under the foot to separate the adhesive.

    • If the pick feels stuck, apply more heat before continuing.

  3. KA4JaUNEFAgpqY56
    KA4JaUNEFAgpqY56
    Y2Vkf1l6PHjv3IKh

    • Use tweezers, or your fingers, to remove the mouse foot.

  4. eKE1XtZmqisyZGun
    eKE1XtZmqisyZGun
    alMrMrS3UJ2TNZNd
    jMFCfncssstegKjl

    • Repeat the previous two steps for the three remaining feet.

    • The front foot doesn't cover any screws—if you're only removing the mouse feet to open the mouse, don't remove this foot.

  5. oWXG2CsTDINFSF63
    oWXG2CsTDINFSF63
    ndCu6ruFeeaC1OyD
    AUbpMaLD6kZQxWWU

    • For installing new mouse feet or reusing your old ones:

    • Use a pair of tweezers or a spudger to remove any large chunks of leftover adhesive.

    • Thoroughly clean the bottom of the mouse with isopropyl alcohol and a lint-free of microfiber cloth, and allow the surface to dry completely.

    • Peel your new mouse feet away from their adhesive liners and press them firmly into place.

    Why are we removing leftover adhesive if we went to the trouble of heating for full removal (and reuse)?

    This makes no sense. Might as well just rip em off!

    craigalanelliott -

Abschluss

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Tinte & Feder

Alex Diaz-Kokaisl

Mitglied seit: 16/01/22

69204 Reputation

0 Kommentare