Makita Jack Hammer HM1307CB Cord Removal

Geschrieben von: Taylor Dixon
  • Kommentare: 0
Makita Jack Hammer HM1307CB Cord Removal

Schwierigkeitsgrad

Moderate

Schritte

3

Zeitaufwand

Keine Schätzung

Einleitung

This is a prerequisite guide for the removal of the power cord in a Makita jack hammer HM1307CB. If you need to replace the power cord, follow the cord replacement guide.

  1. 5xS6cyGCKDISSkkN

    • Remove the black Phillips screw from the strain relief plate.

    • Loosen the two silver Phillips screws that hold the stripped ends of the power cable in the green terminal on the controller. These screws do not need to be removed.

  2. Aq46idIPGasA5nVY
    Aq46idIPGasA5nVY
    QsZedcjZfTHPCEOV

    • Remove the strain relief plate.

    • During reassembly, hook the right edge of the strain relief plate under the lip to the right of the cord before pressing it into place and reinstalling the Phillips screw.

  3. sXMe3obdnvhotSwI
    sXMe3obdnvhotSwI
    DKFVav236Ug2Ulbv
    3GdFQY1ACEWuIPYv

    • Remove the power supply cord from the jack hammer.

    • As you remove the cord, note the position of the cord guard. During reassembly, make sure the collar of the cord guard fits back into its slot in the handle.

    • When reinserting the two exposed wire ends into the green terminal:

    • First, compress the wire ends so they are relatively flat.

    • Then, insert each wire end into the green terminal, noting the polarity of the cables: the black cable should go into the upper slot, and the white cable should go into the lower slot (as shown in the third photo of this step).

    • Finally, gently tighten the screws until the wires are secured.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Taylor Dixon

Mitglied seit: 26/06/18

63211 Reputation

0 Kommentare