Einleitung

  1. ItMhABCccXC43HZC
    • Before you begin, be sure to unplug the speaker.

    • First, remove the eight screws on the speaker's back panel. These screws should be located on the top and bottom corners of the back, as well as along the sides.

    • Remove the 7.5 mm Phillips-head screws using a Phillips #1 screwdriver with a J sized head.

  2. DvRNK6QLVMvJhogo
    DvRNK6QLVMvJhogo
    PEfxc6e2nMtEYElZ
    • Next, remove 4 more 7.5 mm Phillips-head screws on the top part of the speaker (where the power buttons and extra BASS buttons are located). Two of the screws are located on the underside of the handle and are hidden beneath black rubber covers. Remove the covers and use a Phillips #1 screwdriver to unscrew the screws.

    • The remaining two 7.5 mm Phillips-head screws are located on the base of the indented section of the speaker, pictured here. They are also hidden beneath black rubber covers. Repeat same process in removing the screws.

  3. IEMK2eEVXCYcdNbT
    IEMK2eEVXCYcdNbT
    K5L4OSuEyObfSbNW
    • Caution: Be careful not to touch the capacitor wires as you work. If possible, use a capacitor discharge probe to safely rid the capacitors of dangerous charges.

    • Gently lift up the entire top plastic section of the speaker. Do so slowly, the section is still connected to the circuitboard by a belt.

    • Gently remove the belt from its junction on the board, and after doing so the top plastic casing of the speaker will be fully detached.

    What’s the wire that’s being held, mine is burnt out and is split into 2 pieces at the end?

    david castro -

  4. cQJAJNaRiVn4wuvO
    cQJAJNaRiVn4wuvO
    jb1HecsPjCZTRMGI
    • Additionally, the sides need to be taken apart. You will need to take out 4 additional 7.5 mm Phillips-head screws on either side. These screws are located beneath larger grey pads with adhesive on them at the side corners of your speaker.

    • Remove the pads slowly, as the adhesive makes them tougher to remove and you do not want to rip them.

    • Use an opening tool to help take out the side shell from the rest of the speaker.

    • This step can be difficult to perform and do not hesitate to use some force, there are no delicate components on the immediate underside of the side panel.

  5. FOSBSr2ywJNkDFeD
    • The speaker should now be stripped of its basic shell except for the bottom and front panels.

    • You have now disassembled the top casing of your speaker and you are prepared to make replacements of components!

Abschluss

To reassemble your device, follow these instructions in reverse order.

Aris Recidoro

Mitglied seit: 26/01/17

402 Reputation

0 Kommentare