Motorola Moto E4 Plus Motherboard Assembly

Written By: Dominik Schnabelrauch
  • Comments: 0
Motorola Moto E4 Plus Motherboard Assembly

Difficulty

Moderate

Steps

6

Time Required

20 - 30 minutes

Introduction

Motherboard Assembly prereq

  1. FX1cDOGpcyLIVGtC

    • Remove the two 2.9 mm Phillips screws.

  2. gYiWtfhsnHTpASr3
    gYiWtfhsnHTpASr3
    qUFBVrMTabQr6Rsi
    WaRI6UoDMQODCvEp

    • Use the edge of a spudger to pry up the flap of the ZIF connector located below the SIM slot on the left side of the motherboard.

    • Use a pair of tweezers to pull the power and volume button flex cable out of the ZIF connector.

    • To reattach ZIF connectors like this one, carefully insert the flex cable into the ZIF connector up to the marked line on the cable, and then close the locking flap.

  3. aOQCHRCCZuTMYjOJ
    aOQCHRCCZuTMYjOJ
    6JhDtdhMbGAye1qb

    • Use a pair of tweezers to pry up and disconnect the antenna cable.

  4. ldwJg2KQKHrfbViD
    ldwJg2KQKHrfbViD
    ExeLaQZUPCxbTWb2

    • Use the flat end of a spudger to pry up and disconnect the interconnect flex cable.

  5. bfDl3W1iYCKGV4RL
    bfDl3W1iYCKGV4RL
    FnQOkfDXQpvyCKOF
    JSTORVdSDKKvMATK

    • Use the tip of a spudger or an opening pick to pry up the flap of the ZIF connector, located in the bottom right corner of the motherboard.

    • Use a pair of tweezers to pull the display flex cable out of the ZIF connector.

  6. JTbcM3tCJUjWWLjI
    JTbcM3tCJUjWWLjI
    qHEHHnld6ufuZSmu

    • Grasp the motherboard by the top corners and remove it by lifting up and pulling it carefully out of its recess.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dominik Schnabelrauch

Member since: 23/11/16

167336 Reputation

0 comments