Battery Disconnect

Heat an iOpener and apply it to the back cover's right edge for two minutes.

Apply a suction cup to the back of the phone, as close to the middle of the right edge as possible.

Pull up on the suction cup with a strong, steady force to create a gap between the back cover and the frame.

Insert an opening pick into the gap.

Slide the pick along the right edge to slice the adhesive.

Leave the pick in the bottom right edge to prevent the adhesive from resealing.

Apply a heated iOpener to the back cover's bottom edge for two minutes.

Rotate the pick around the bottom right corner to slice the adhesive.

Slide the pick along the bottom edge to slice the adhesive.

Leave the pick in the bottom left edge to prevent the adhesive from resealing.

Apply a heated iOpener to the back cover's left edge for two minutes.

Rotate the pick around the bottom left corner to slice the adhesive.

Slide the pick along the edge to slice the adhesive.

Leave the pick in the top left edge to prevent the adhesive from resealing.

Apply a heated iOpener to the back cover's top edge for two minutes.

Rotate the pick around the top left corner to slice the adhesive.

Slide the pick along the top edge to slice the adhesive.

Lift the back cover from the phone and remove it.

Insert an opening pick between the right edge of the camera bezel and the motherboard cover.

Slide the pick back and forth along the edge to slice the adhesive.

Insert an opening pick between the left edge of the camera bezel and the motherboard cover.

Slide the pick back and forth along the edge to slice the adhesive.

Lift the camera bezel from the phone and remove it.

This is a good point to test your phone's functionality before sealing it up. Use this guide to run a hardware test. Be sure to power your phone back down completely before you continue working.

If you are replacing the fingerprint sensor or screen assembly, use this guide to calibrate the fingerprint sensor.

Follow this guide to replace the back cover and camera bezel adhesive.

Insert the pointed end of a spudger underneath the tape that connects the wireless charging coil to the speaker on the bottom left of the phone.

Slowly lift the spudger up until the tape detaches from the speaker.

Insert a spudger underneath the tape that connects the wireless charging coil to the daughterboard cover on the bottom right of the phone.

Slowly lift the spudger up until the tape detaches.

Use a Phillips screwdriver to remove the 10 4 mm screws securing the motherboard cover.

There's adhesive under the motherboard cover that secures the cover to the motherboard.

Apply a heated iOpener between the bottom of the motherboard cover and the top of the battery for two minutes.

Insert an opening tool between the motherboard cover and the midframe.

Pry up with the opening tool until you are able to grab the motherboard cover with your fingers.

Slowly pull the motherboard cover up and away from the phone and remove it.

Use your fingers to move the graphite film that covers the battery out of the way.

Use the pointed end of a spudger to pry up and disconnect the battery's press connector.